How to use NodeMCU with ESP-01

When using a newly bought ESP-01 module from Ai-Thinker with minicom serial terminal, one should «send» commands to the module with C-j (a simple Enter key won’t work). AT commands may be used out of the box.

To build NodeMCU firmware, I used marcelstoer/nodemcu-build Docker image that contains the toolchain. This left me with a nodemcu_float_master_*.bin file that needs to get onto the board. Time to flash NodeMCU and get hacking! I used esptool and nodemcu-uploader:

pip inistall esptool nodemcu-uploader

GPIO0 pin has to be pulled down prior to powering the board to enter the flashing mode (I used a pin to short GND and GPIO0). Now the command to run is:

esptool.py --port /dev/tty.SLAB_USBtoUART write_flash -fm qio 0x00000 bin/nodemcu_float_master_20180210-1805.bin

This has to be done only once (unless you change the firmware and/or its config).

From now on, project *.lua files can be uploaded to the board via

nodemcu-uploader --port /dev/tty.SLAB_USBtoUART upload *.lua
git.md